Machining of Complex Sculptured Surfaces

Preface.- 1.Flank milling of complex surfaces.- 2.5-axis flank milling of sculptured surfaces.- 3. High performance five axis milling of complex sculptured surfaces.- 4. Milling tool-paths generation in adequacy with machining equipment capabilities and behaviour.- 5. Intelligent optimisation of 3-axis sculptured surface machining on existing CAM systems.- 6. Process planning for 5-axis milling of sculptured surfaces based on cutter´s accessibility analysis.- 7. Manufacturing of sculptured surfaces using EDM and ECM processes.- References.- Index.

J. Paulo Davim received his PhD degree in Mechanical Engineering from the University of Porto in 1997 and his Aggregation from the University of Coimbra in 2005. Between 1986 and 1996, he was lecturer in University of Porto. Currently, he is an aggregate professor at the Department of Mechanical Engineering of the University of Aveiro and the Head of MACTRIB - Machining and Tribology Research Group (http://www2.mec.ua.pt/machining). He has more than 25 years of teaching and research experience in manufacturing, materials and mechanical engineering, with special emphasis on machining and tribology. He is the Editor in Chief of six international journals, a guest editor of journals, an editor of books, a book series editor and a scientific advisor for many international journals and conferences. Presently, he is an editorial board member of 20 international journals and acts as a reviewer for more than 60 prestigious ISI web Science journals. In addition, he has also published as author and co-author more than 30 book chapters and 300 articles in journals and conferences (more than 150 articles in ISI Web Science, h-index 17).ion from the University of Coimbra in 2005. Between 1986 and 1996, he was lecturer in University of Porto. Currently, he is an aggregate professor at the Department of Mechanical Engineering of the University of Aveiro and the Head of MACTRIB - Machining and Tribology Research Group (http://www2.mec.ua.pt/machining). He has more than 25 years of teaching and research experience in manufacturing, materials and mechanical engineering, with special emphasis on machining and tribology. He is the Editor in Chief of six international journals, a guest editor of journals, an editor of books, a book series editor and a scientific advisor for many international journals and conferences. Presently, he is an editorial board member of 20 international journals and acts as a reviewer for more than 60 prestigious ISI web Science journals. In addition, he has